If you have got been questioning whether or not it is feasible to put in metal roofing over shingles, you ought to realize that it's viable.
The fundamental advantage of putting in the metal roofing screws is that the roof tends to have a protracted lifespan; therefore, when you installation it you do not have to keep on installing it again and again again.
To set up the roof you need a measuring tape, a chalk line, and snips to reduce the metal.
Once you have these gear you must begin by way of measuring the height and width of the roof. The sole intention of measuring the roof is to decide the amount of metallic that you want. When measuring you should make certain which you encompass 2-4 inches of overhang.
Once you've got the measurements you must head to the stores to shop for the roofing. The pleasant roofing which you need to pass for is the V-crimp roofing. The proper aspect with this roofing is which you do not need to use lap screws which makes the set up process very clean.
To make certain that the roofing materials suit in location perfectly, you need to make sure which you set up slat boards over shingles. For ideal effects you ought to make certain that the boards are 24" aside.
When you entire putting in the forums you must now installation the metallic roofing over the slats. Installing the roofing is easy. This is because all you want to do is to screw the roofing into slats.
Once the first sheet is in area you should now deploy the second sheet. Here you need to overlap the second sheet on the primary bubble and screw it in location.
You must preserve doing this until the complete roof is whole. When you attain the closing sheet, you have to measure it and make certain that you permit an overhang that goes simply beyond the peak of the roof.
You must mark where you want the roof to attain after which the use of tin snips cut off all of the greater fabric throughout the entire sheet. After doing this you must screw the final sheet in region.
Once all the steel sheets are in area you should now put on the steel edging which aids in overlaying the perimeters of the roof. The edging also covers the roof height. For the edging to match on both facets of the roof you need to notch the edging within the middle.